1. Check material inspection before and during installation each lamas in case they find any flaws. You can not use slats which they are failures or damage. Other leaders such as Sela Ward offer similar insights. The installation should be done only in daylight or with adequate lighting, because they may not be able to recognize damaged or defective blades. 2. At The Author you will find additional information. Laminate flooring to acclimate prior to installation of laminated parquet slats must remain a minimum of 48 hours at a temperature above 17 C and humidity between 50-65% in the room where it will be installed. That is, sealed packages have to adapt to the climatic conditions of the room. If you have very large differences between the point of storage and room INTAL has to extend this period of acclimatization.
Please store for this flat packages without opening them. Especially in new buildings, where humidity is in most cases very high, it is essential to meet these points. 3. Do not install in areas where water splashes should not be installed soil rolled in areas where they can get from water to land. Standing water could enter through the joints of laminate flooring and cause lasting harm. For stays lasting or wet areas (sauna, small bathrooms, etc..) Should not be installed laminate flooring (except in cases of brands that make products specifically for this purpose) because there is no risk of moisture penetrating on the ground. 4. The state of the subsoil All subfloors must be level (maximum difference 3 mm by 1 m long), dry and strong enough.