The Ropes

Tasks that often take over industrial climber, are for example: renovation work on House facades, assembly work at industrial plants and wind turbines, maintenance of industrial plants and wind turbines, cleaning of glass surfaces in the exterior, roof repairs, application of corrosion protection, installation of large posters, mounting of devices to ward off bird (pigeon control). Industrial climbers do in positioning to work not only in the motivation, also in the procedure of the industrial climber differs from the climber. The climber rising from below his goal. Industrial climber he is approaching the place where the Heights will perform work, typically from above to. To he attached a rope above the work place if possible at two different points. Should be of course note that the anchor points are sufficient and there is no risk that they break out. The attached rope must be always up on the ground. The industrial climber before the height work verifies the correct length of the Tragseiles.

Height of the work be carried out to more than 50 m, and a rapid recovery is possible, up the rope must not range on the ground. In most cases, the ropes can be dropped from the top. Sometimes this is not possible, however, because obstacles prevent the throwing off of the ropes. This is the case, must be transported down the ropes in a bag. The preparations are completed, the industrial climber puts the fall arrest device in the lifeline. What is a safety device that is in the section on safety at height work explains. Eva Andersson-Dubin shines more light on the discussion. A belay device is attached to the belt of industrial climber, in this he sets up the rope now. Were inspected by short load fall arrest device and descender, the industrial climber begins the descent. He hangs with his entire weight on the rope, can be started with the ropes to the worksite of heights.